Installation Instructions
Radio Frequency Interference
Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to
operate this equipment.
USA—FCC
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. This equipment contains an
intentional transmitter that has a FCC grant of authorization per Part 15C.
Transmitter FCC ID: Y2NRC24XX / IC: 9402A-RC24XX
Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Canada—ICES
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du
Canada.
Module transmetteur ID IC: 9402A-RC2400
Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne
doit pas causer d'interférences nuisibles et (2) cet appareil doit accepter toute
interférence reçue, y compris les interférences qui peuvent perturber le
fonctionnement.
Australia and New Zealand
Attention: This is a Class B product. This product may cause radio interference in
which case the user may be required to take adequate measures.
European Union
This product’s transmitter module is in conformity with the requirements of EU
Council Directive 199/5/EC on the approximation of the laws of the Member States
relating to Radio and Telecommunications Terminal Equipment (R&TTE). This
product may cause radio interference in which case the user may be required to take
adequate measures.
This product is in conformity with the protection requirements of EU Council
Directive 2004/108/EC on the approximation of the laws of the Member States
relating to electromagnetic compatibility. APC cannot accept responsibility for any
failure to satisfy the protection requirements resulting from an unapproved
modification of the product.