Installation Instructions

NetBotz Wireless Sensor Pod 180 Installation Guide

Configuring and Monitoring Sensors

Once your wireless network is installed and communicating, configure sensors

and begin monitoring your system using the software interface for the

appliance.

See your appliance installation and quick configuration manual for

system installation details and for instructions on accessing the

software interface of the appliance.

When two NBES0311 temperature sensors are connected to the top and bottom

of the Wireless Sensor Pod, the combined length from top to bottom is 75.25

inches.

Receiving and sending data

The Coordinator and any Routers on the wireless sensor network pass data back

and forth between the host appliance and any End Devices as necessary. If there

is a significant change, each device sends its sensor data every 30 seconds. If

there is no change, the Wireless Sensor Pod waits up to 3 minutes before

sending sensor data to indicate it is still alive.

Door Contact sensors send an update immediately when the status of the sensor

changes.