Installation Instructions

20
NetBotz Wireless Sensor Pod 180 Installation Guide
Using the Reset Button
The Reset button on the side of the Wireless Sensor Pod is used to reboot the
pod, or reset the pod to the factory default settings.
To protect against false push button attempts, there is no effect if the Reset
button is pressed for less than 100 milliseconds.
Reboot. Press and hold the Reset button for no more than 3 seconds. The
Status LED will flash green.
After you release the button, the status LED will rapidly flash yellow for about
40 seconds, turn solid yellow for 10 seconds, then flash a quick green, yellow,
red LED sequence. The pod will operate in the mode in which it was configured
before the reboot.
Reset to factory defaults. Press and hold the Reset button for at least 5
seconds. The status LED will rapidly flash green, and after about 5 seconds,
change to solid red.
Release the Reset button when the LED is solid red. The pod will reset, erase its
current settings, and return to Router mode, the factory default.
Note: The Reset button is disabled while the sensor pod is booting.
Once startup is complete, the button functions normally.