Installation Instructions

14
NetBotz Wireless Sensor Pod 180 Installation Guide
Powering a Router
A Wireless Sensor Pod must be connected to an AC-USB power source to
become a Router. Once its extended address is added to the commission list in
the Advanced View, and power is applied, the pod is automatically configured
as a Router.
Warning: Do not use a NetBotz appliance as the USB power
source for a Router device.
To configure a Wireless Sensor Pod as a Router:
1. Mount the pod using the instructions in “Mounting the Wireless Sensor
Pod” on page 10.
2. Ensure the extended address of the pod is added to the commission list in
the Advanced View.
3. Plug the pod into the included AC-USB power source.
Internal sensor listing
When a Router is selected in the Navigation Pane in Advanced View, the
following internal sensors are listed in the Sensor Pane (along with any attached
external sensors):
Sensor Description
Temperature The internal temperature sensor reading.
Humidity The internal humidity sensor reading.
Dew Point The calculated dew point.
RSSI The Received Signal Strength Indicator. This indicates the
strength of the signal the Router receives from its parent
(either another Router or the Coordinator).
A reading above 30% RSSI is ideal.