Operation Manual

NetBotz CCTV Adapter Pod 120
NetBotz CCTV Adapter Pod 120 3
Your video source should now appear in your Advanced View Cameras pane. Once
configured, you can use the video source in the same ways in which you use NetBotz
Camera Pod 120s.
• To specify a unique label for the CCTV Adapter Pod: Double-click on Camera Pods,
select the CCTV Adapter Pod from the selection list, and then click Labels and specify
labels as usual.
• To configure camera motion sensor settings on your CCTV Adapter Pod: Double-click
on Camera Pods, select the CCTV Adapter Pod from the selection list, and then click
Motion and configure camera motion sensor settings as usual.
• To configure sensors and thresholds for your CCTV Adapter Pod: Double-click on
Camera Pods, select the CCTV Adapter Pod from the selection list, and then click
Sensors and configure sensor settings and thresholds as usual.
NetBotz CCTV Adapter Pod Sensor Types
A NetBotz CCTV Adapter Pod 120 includes the following sensors:
• Door Switch: State sensor that reports whether a door is “open” or “closed.”
• Camera Motion Sensor: State sensor that reports the presence of motion in the camera
field of view.
• External Microphone: State sensor that reports whether an external microphone or
microphone override plug is inserted into the External Microphone jack on the pod.
• Speaker: State sensor that reports whether a speaker plug is inserted into the Speaker
jack on the pod.
• TV Signal: State sensor that reports the presence or absence of a CCTV video signal.
Enabling the Internal Microphone
The CCTV Adapter Pod 120 comes with an internal microphone override plug installed.
When inserted into the External Microphone jack, this plug disables the internal microphone.
To enable the internal microphone, unplug the internal microphone override plug from the
External Microphone jack.
About the Surveillance Advisory Sticker
Your CCTV Adapter Pod 120 contains, and the BotzWare software enables, audio/visual and
recording capabilities. Please see “About the Camera Pod 120” in the About Your Appliance
booklet that was included with your appliance for information regarding these audio/visual
and recording capabilities. For your convenience, we have included a sticker which may be
adhered to the unit or wall.
PN: 01616D05
Note
Pan and Scan Visual Mode is not available for use with CCTV Adapter Pod video
sources. Therefore, the Visual Modes button will be grayed out when CCTV
Adapter Pods are selected.