User manual

Doc: HMSI-168-92 Rev: 3.00Netbiter EasyConnect Gateway User Manual
Installation on an Ethernet Network 33
7. Installation on an Ethernet Network
! NetbiterEasyConnectgatewaysshouldonlybeinstalledinnetworkswithfirewall
protection.Contactyournetworkadministratorifindoubt.
InordertoconnecttoNetbiterArgos,NetbiterEasyConnectgatewaysrequireoutbound
(outgoing)accesstotheInternetontheTCPportslistedbelow.
Ports for connecting to Netbiter Argos
Connectionattemptswillbemadeto3differentserverswithatimeoutof30secondseach.
Thismeansthatit
maytakeupto4min30sectoestablishaconnectionforEC150/220/250
(3portsx3serversx30seconds).
Other ports
Thefollowingportsmayalsoneedtobeopenedinthefirewall:
•502 DefaultportforModbusTCP
• 8080 Extrawebserver
7.1 Network Setup - Dynamic IP Address
WhenusingDHCP(thedefaultsetting),thereisnoneedtoconfigureanyoftheIPaddress
relatedsettings.Theonlychangesthatmayberequiredarethesettingsneededtopass
throughaproxyserveronthe network,see“LocalProxySetup”onpage42.
Netbiter model TCP ports
EC310, EC350 443
EC150, EC220, EC250 5222, 443, 80 (the ports are tried in the order shown)