User manual

Doc: HMSI-27-240, Rev: 1.2

Netbiter Remote Access User Manual

Chapter 3

3. Installation - New Netbiter Argos Account

The following are required for installation and activation:

• A Netbiter EasyConnect Gateway EC350 or EC310.

• The printed document with the System ID and Activation Code supplied with the product.

• For a wireless model - a Netbiter SIM card, or a SIM card from another operator.

3.1. Installation Procedure

1. Perform the physical installation of the Netbiter

EasyConnect according to the documentation supplied

with the product. The unit should be powered up before

proceeding with the steps below.

2. Open a web browser and go to www.netbiter.net

3. Click the link Create an account, as shown to the right.

4. Fill in the requested account information in the form.

Make a note of the account name and password for safe-

keeping, as these will be used when accessing the

account. See the following page for tips about passwords.

Important! - The product’s System ID and

Activation Code (see the illustration below) are supplied on a printed sheet in the package

containing the Netbiter EasyConnect Gateway. This is a valuable document that should

be stored safely! If this document is missing, contact Netbiter support at support.netbit-

er.com

5. Read and accept the terms and conditions for the service, by checking the box provided.

6. Finally, click on the Register button. When the account is created, an e-mail containing an activa-

tion link will be sent to the e-mail address provided in the account information.

SP1498 rev. 1.00

Netbiter Argos Activation Details

Netbiter is a complete m2m remote management solution

that enables you to monitor, control and supervise the

performance and operation of remote equipment and

installations via Ethernet, GSM, GPRS or 3G networks.