User manual

Configure Remote Access in QuickConnect 34
Doc: HMSI-27-240, Rev: 1.2
Netbiter Remote Access User Manual
7.2. Connect to the Remote Device
After the configuration is complete, click on the blue Connect button to open the tun-
nel connection to the remote device.
When the connection is up and running the time elapsed and the amount of data traffic
can be seen in the green bar at the top of the window.
From this point on it will be possible to use device-specific software tools for programming, configuring,
debugging and analyzing the remote device.
Please see the device/software manufacturer’s own documentation for further information.
7.3. Close QuickConnect and Log out
Depending on the method selected, the QuickConnect application and its associated tunnels and chan-
nels will close or log out in the following ways:
• When the X in the upper right corner of the window is clicked, the application is minimized to
the system tray and the user is logged out. Any open tunnel will stay open.
• Clicking the logout button will log the user out and close any open tunnel.
• After 60 minutes of inactivity, the QuickConnect window will automatically log the user out. Any
open tunnel will stay open.
• Unless closed earlier, an open tunnel will automatically close after 8 hours. The closure is definite
and will terminate any ongoing communication.
• Opening a new communication tunnel to a system will automatically close any existing tunnel to
that system.
Minimize button
Logout button