User manual

Configure Remote Access in QuickConnect 32
Doc: HMSI-27-240, Rev: 1.2
Netbiter Remote Access User Manual
2. Configure the port-forwarding channel as shown below.
7.1.5. Custom Device Configuration
If the device you wish to connect is not available in a ready-made configuration in the list, it is still pos-
sible to add the device, by configuring a Custom device. Follow the steps below.
1. Click the Custom button.
2. Enter a name for the configuration and click the Add Device button to save.
3. Now make the required settings for a new serial or network bridge channel, as described in the
following section.
Enter the port
on the local
PC.
Enter the port
on the remote
device.
Enter the IP
address for the
remote device