User manual

Configure Remote Access in QuickConnect 31
Doc: HMSI-27-240, Rev: 1.2
Netbiter Remote Access User Manual
7.1.3. General Network Bridge Configuration
After adding a first network bridge connection, it will be necessary to define the IP address for the virtual
network adapter. As only a single network adapter is allowed on the remote network, this must be con-
figured for all network bridge connections - in the General Network Bridge Configuration.
1. Click the down arrow to enter the configuration.
2. Enter the required IP address for the network bridge connection, and also specify the subnet
mask to use on the remote network.
Note that it is important to ensure that this IP address is not already in use on the remote network,
as there may be addressing conflicts.
7.1.4. TCP/UDP Port Forwarding
Whenever possible, a channel within a tunnel configuration should be specific for the device to be ac-
cessed. This type of connection allows you to specify the exact IP address, network protocol and remote
port to connect to. Any other IP address not specified in this configuration will not be accessible.
Using a network bridge that provides access to the entire network is certainly practical, but opening up
the network for general access also raises security concerns.
1. Click the link for Add new Channel (TCP or UDP).