User manual

Configure Remote Access in QuickConnect 30
Doc: HMSI-27-240, Rev: 1.2
Netbiter Remote Access User Manual
7.1.2. Network Bridge Configuration
A network bridge connection is much like a traditional VPN connection, in which a virtual network
adapter uses its own IP address on the remote network and has general access to that entire network.
Note that you will need two IP addresses for use on the remote network; one for the virtual net-
work adapter and one for the physical LAN port on the Netbiter EasyConnect. This may require
contacting the network administrator.
Note also that the LAN port must be enabled for Network bridge at Netbiter Argos. See page 22.
1. Click + Add New Device
.
2. Select a network bridge device configuration to add.
3. Enter a new name for the device, if required. Entering an IP address in the field provided here is
not mandatory, but can instead be used if using multiple channels in the same tunnel, as a way to
keep track of the different devices on the network.
The actual IP address to use for the virtual network adapter on the remote network should be entered
in the General Network Bridge Configuration. See below.
4. When finished entering the configuration data, click Add Device, which saves the configuration.