User manual

Configure Remote Access in QuickConnect 29
Doc: HMSI-27-240, Rev: 1.2
Netbiter Remote Access User Manual
7.1.1. Serial Channel Configuration
To configure a virtual serial channel configuration you will need to know the virtual serial port on the
PC and the physical serial port at the other end of the connection, i.e. the RS-232 or RS-485 port on the
Netbiter EasyConnect.
Click the Add device button to complete the configuration.
An example of a completed serial configuration. The tick in the box to the left denotes an enabled
device. This configuration can be changed at any time, by clicking on the down arrow, as indicated
below. This re-opens the configuration for further editing.
Check that the
local serial port
is not occupied.
Click the
Down/up arrow
to show/hide
the configura-
tion.
Tick denotes
an enabled
device.