User manual

Doc: HMSI-27-240, Rev: 1.2
Netbiter Remote Access User Manual
Chapter 6
6. Install QuickConnect
QuickConnect is the driver required on the PC to be used for remote access.
The file can be downloaded from the presentation page for the Netbiter EasyConnect Gateway at
Netbiter Argos, as in the illustration below.
Save the file to the PC and run it to install the application. Follow the instructions as they appear
on-screen.
•Note 1: Apart from the QuickConnect driver, this installation automatically installs a total of 3
other software components (OpenVPN, Serial IP and Windows TAP). None of these compo-
nents require configuration and do not need to be opened or run manually.
•Note 2: Remember to enable the serial port on the Netbiter EasyConnect Gateway. See 5.1.1.
After the installation is complete there will be a new icon for QuickConnect on the desktop. To run and
use the application, see the following chapter.