User manual

Configuring Remote Access in Netbiter Argos 24
Doc: HMSI-27-240, Rev: 1.2
Netbiter Remote Access User Manual
5.2. LAN Configuration
These settings affect the 2nd Ethernet port on the Netbiter EasyConnect Gateway, i.e. the LAN port.
This port is the one used for all onward connections to the Ethernet network on the remote side of the
tunnel connection.
These settings will enable/disable the LAN port, with the following options:
• Use configuration as set locally ... - The LAN port will use the configuration as set locally in
the gateway. See the Netbiter EasyConnect User Manual for further details.
• LAN interface not in use - The port is disabled and cannot be used for any purpose.
• Get IP address automatically... - The LAN port will receive its IP address from a DHCP
server on the remote network.
• Manually set a fixed IP address... - Requires a suitable IP address and Netmask for the remote
network to be entered in the 2 fields provided. Contact the network administrator for further
information.
Click the Save button to save all changes on this page.
5.3. Synchronize the Configuration
The final step to perform at Netbiter Argos before the Netbiter EasyConnect Gateway can be used for
remote access is to synchronize the configuration, i.e. the settings made at Netbiter Argos must be trans-
mitted to the Netbiter EasyConnect Gateway.
Click the green button to synchronize. There may be a
short delay before the unit is back online again.