User manual

Doc: HMSI-27-240, Rev: 1.2
Netbiter Remote Access User Manual
Chapter 5
5. Configuring Remote Access in Netbiter Argos
Now that the Netbiter EasyConnect Gateway has been added to Netbiter Argos and activated, the next
step is to configure the settings for remote access.
Note that the configuration pages described here are taken from the View & Control service.
When running in Manage & Analyze, these pages will appear slightly different.
Open the system’s configuration page from Management >> Configuration.
The switch to the right indicates the current mode for the Netbiter EasyConnect Gateway. This switch
can be used at any time to switch between remote management mode and remote access mode.
The settings found here for remote access will determine the following:
• The interfaces to be used for remote access
• The protocols to be used for remote access
• The IP addresses and ports available for remote access.
5.1. Remote Access
To determine which types of connections/ports are relevant for the device you wish to connect remotely
to, please see the documentation for that product. See also the overview on page 6.
5.1.1. Serial Ports
The first two switches here are for enabling the required serial port(s)
on the Netbiter EasyConnect Gateway from which to connect to re-
mote devices. See the device’s own documentation for the correct inter-
face to use. The available serial interfaces are:
•RS-232
•RS-485
Note that for security reasons, any interfaces not currently in use should remain disabled.