User manual

Installation - Existing Netbiter Argos Account 16
Doc: HMSI-27-240, Rev: 1.2
Netbiter Remote Access User Manual
4.2. Activate the Netbiter EasyConnect
The definition of a field system is one Netbiter Gateway plus all of the devices connected to it. A field
system may have multiple devices, but only a single gateway. If an account has e.g. two connected
Netbiter Gateways, then there are two field systems.
In the setup procedure described above, a Netbiter Gateway was added to the user account and used to
create a new field system. This system must now be activated before it can be used.
1. Click Management >> All Systems >> Inactive. The field system just added will be found in
the list of inactive systems.
2. For the field system to be activated, click the Activate link on the right.
3. Select the radio button for “Use system for Remote Access.” This setting will disable/hide all
of the configuration options available when using the unit for logs, alarms etc, as found when in
“standard” operating mode (also known as Remote Management). Note, however, that it is pos-
sible at any time to switch between these two operating modes.
4. Click the Activate button.