User manual

Installation - New Netbiter Argos Account 14
Doc: HMSI-27-240, Rev: 1.2
Netbiter Remote Access User Manual
3.3.4. 3G/GPRS connection (EC350 only)
The 3G/GPRS connection is enabled by default, and all that remains for this connection is to enter the
SIM card number and the mobile network settings. After clicking the Activate button in 3.2. above, pro-
ceed to the tab for the Mobile network, as shown below.
Netbiter SIM Card
1. Select the option for I have a Netbiter SIM card.
2. Enter the phone number provided with the Netbiter SIM card.
3. Click Send to transmit the pre-configured mobile network settings to the Netbiter Gateway.
Custom or Standard SIM Card
1. Select the option for I have a custom or standard SIM card.
2. Enter the Access Point Name (APN) for the SIM card. If an APN username and password are
required, enter these too. This information should be provided by the mobile network operator.
3. Click the Send button to transmit the mobile network settings to the Netbiter Gateway. The unit
will come online after a few minutes.
LED indications
When the unit is online and functioning normally, there will be the following LED indications.
•The Gateway LED on the product casing will show steady green for normal operation.
•The Modem LED will show steady green for a connection to Netbiter Argos (flashing green
when searching for available networks).
If either of these LED:s is showing red, check all connections and consult the product’s documentation.
The LED:s on the front panel of the unit can also be used to indicate the signal strength of the
3G/GPRS connection. Please see page 20 for further details.