User Manual
Table Of Contents
- User Manual
- LEGAL NOTIFICATION
- Table of Contents
- List of Figures
- 1. Introduction
- 2. AirCheck G2 Tester Physical Features
- 3. The AirCheck G2 Home Screen
- 4. Discovering Networks and Access Points
- 5. Viewing Channel Usage
- 6. Discovering Clients
- 7. Detecting Interferers
- 8. Using AutoTest to Diagnose Your Network Health
- 9. Conducting a Site Survey Using AirMapper
- 10. Testing Ethernet for Access Point Backhaul
- 11. Companion Services
- 12. Customizing the Tester for your Network
- 13. Verifying Connectivity and Coverage
- 14. Locating an Access Point, Client, or Interferer
- 15. Performing a Network Roaming Test and AP Range Test
- 16. Conducting iPerf Performance Testing
- 17. Saving Test Sessions, Packet Captures, and Screenshots
- 18. Managing Files on the AirCheck G2 Tester
- 19. All AirCheck G2 Settings
- 20. Maintenance
- 21. Specifications and Compliance
- Appendix A: Quick Reference: Examining your Network Health
- How is my Network Quality?
- What is in the Wireless Environment?
- Can Devices Connect to My Network?
- What is Causing Slow Network Performance or Dropped Connections?
- Are There Security Risks in My Network?
- Where is an Access Point?
- What Networks or Access Points Come into Range as I Move?
- How Can I Document My Network and My Test Session?
Locating an Access Point, Client, or Interferer
79
The Locate Interferer Screen
If you tap Locate from the main Interferer Events list screen,
the Select Interferer screen opens. Select the interfering
device type you would like to locate, and then tap Apply.
If you tap Locate from a specific interfering device’s
Interferer Event Details screen, the AirCheck G2 begins
attempting to locate the selected device.
The following information shows on the Locate Interferer
screen:
Interferer Type: The type of interfering device you are trying
to locate.
Last Seen: The time elapsed since the device was last
detected.
Signal Strength Meter: Visually displays the interferer’s real-
time signal level reading.
Signal Strength Line Graph: Visually displays the interferer’s
signal level over time and the highest signal strength
recorded (high watermark).
Figure 54. Locate Interferer Screen
Sound/Mute Icon: Press this b
utton to turn off the
sound. When sound is on, the icon displays in the screen
header, and AirCheck G2 emits an audible single-tone clicking