User Manual

Verifying Connectivity and Coverage
67
Figure 42. Settings > Test Targets Screen
2 Select Test Targets, and then tap Add Test Target.
3 Tap Target to enter an IP address or host name. Select
either the URL Keyboard or IPv4 Address Keyboard, and
type in the address. (In Figure 43, the user has added
etsy.com.)
Figure 43. Configure Target Screen
4 Tap DONE.
5 Choose a Test Type: ICMP Ping or TCP Port Open. Tap
the down arrow to switch between them.
NOTES: If you specify a Ping test to a web server target
that does not respond to Ping requests, the test may fail
even if the target is reachable.
The default test type is ICMP Ping. If you select TCP Port
Open, then you may change the default Port by tapping
Port to open the TCP Port screen, and entering the TCP
port number.
6 Tap Apply to add the test target.
7 Tap Apply again on the Test Targets screen.
NOTE: W
hen you add a test target in Settings > Test
Targets, the target is automatically added to AutoTest and
Connect to Network/AP tests. See Figure 48.