User Manual

Customizing the Tester for your Network
63
4 If the network has not yet been configured on the
current profile, the Configure screen opens; enter the
appropriate credentials on the configuration screen.
See “Networks," page 107 for
more on configuring
network settings.
5 Click the Apply button at the bottom of the screen.
The tester runs a Conn
ection test. Afterward, the credentials
for the Network or AP are retained in the unsaved Profile,
which is denoted with an asterisk (*) (shown in Figure 39).
NOTE: Notice that the Profile name at the top left of the
screen has an asterisk because the Profile has not been
saved with the new credentials. Once you enter security
credentials for an SSID (or multiple SSIDs), save them to a
Profile to avoid losing these settings if another Profile is
loaded or if the tester firmware is updated.
How to: Enter Credentials in the Settings Menu
1 From the Home Screen, tap the Settings button.
2 Select Networks.
3 On the Networks settings screen, tap Add Network. See
Figure 39.
4 Enter the necessary SSID.
Figure 39. Configured Networks in Settings
5 Configure Network settings as needed.
See “Networks," page 107 for more on config
uring
network settings.
6 Tap Apply to add the credentials to the Profile. You
should see your new network’s name listed in
Settings > Networks, as shown in Figure 39.
How to: Enter Credentials in AirCheck G2 Manager
NOTE: See the AirCheck G2 Manager Help for
additional instructions.
1 Connect the tester to a PC with AirCheck G2 Manager
installed.
2 Open the AirCheck G2 Manager application.