User Manual
Table Of Contents
- User Manual
- LEGAL NOTIFICATION
- Table of Contents
- List of Figures
- 1. Introduction
- 2. AirCheck G2 Tester Physical Features
- 3. The AirCheck G2 Home Screen
- 4. Discovering Networks and Access Points
- 5. Viewing Channel Usage
- 6. Discovering Clients
- 7. Detecting Interferers
- 8. Using AutoTest to Diagnose Your Network Health
- 9. Conducting a Site Survey Using AirMapper
- 10. Testing Ethernet for Access Point Backhaul
- 11. Companion Services
- 12. Customizing the Tester for your Network
- 13. Verifying Connectivity and Coverage
- 14. Locating an Access Point, Client, or Interferer
- 15. Performing a Network Roaming Test and AP Range Test
- 16. Conducting iPerf Performance Testing
- 17. Saving Test Sessions, Packet Captures, and Screenshots
- 18. Managing Files on the AirCheck G2 Tester
- 19. All AirCheck G2 Settings
- 20. Maintenance
- 21. Specifications and Compliance
- Appendix A: Quick Reference: Examining your Network Health
- How is my Network Quality?
- What is in the Wireless Environment?
- Can Devices Connect to My Network?
- What is Causing Slow Network Performance or Dropped Connections?
- Are There Security Risks in My Network?
- Where is an Access Point?
- What Networks or Access Points Come into Range as I Move?
- How Can I Document My Network and My Test Session?
Specifications and Compliance
139
locations (e.g., next to the body) as required by the FCC for
each model. The FCC has granted an Equipment
Authorization for this model device with all reported SAR
levels (see below) evaluated as in compliance with the FCC RF
emission guidelines.
This device meets RF exposure guidelines when the antennas
are positioned at a minimum distance from the body. In
order to transmit data or messages, this device requires a
quality connection to the network. In some cases,
transmission of data or messages may be delayed until such
a connection becomes available. Be sure that the
recommended distance is observed until the transmission is
complete.
The exposure standard for wireless devices employs a unit of
measurement known as the Specific Absorption Rate, or SAR.
Tests for SAR are conducted using standard operating
positions specified by the FCC with the device transmitting at
its highest certified power level in all tested frequency bands.
The SAR limit set by the FCC is 1.6 W/kg. The international
guidelines state that the SAR limit for mobile devices used by
the public is 2.0 W/kg averaged over 10 grams of body tissue.
SAR values may vary depending on national reporting
requirements and the network band. Although the SAR is
determined at the highest certified power level, the actual
SAR level of the device while operating can be well below the
maximum value because the device operates at multiple
power levels and uses only the power required to reach the
network.
SAR information on this model device is on file with the FCC
and can be found under the Display Grant section http://
www.fcc.gov/oet/fccid after searching on
FCC ID: WA7-43460AC.
This device is a 2.4-GHz wide-band transmission system
(transceiver), intended for use in all EU member states and
EFTA countries, except in France and Italy where restrictive
use applies.
In Italy the end-user should apply for a license at the national
spectrum authorities in order to obtain authorization to use
the device for setting up outdoor radio links and/or for
supplying public access to telecommunications and/or
network services.
This device may not be used for setting up outdoor radio
links in France and in some areas the RF output power may
be limited to 10 mW EIRP in the frequency range of 2454 MHz
to 2483.5 MHz. For detailed information the end-user should
contact the national spectrum authority in France.