Owner manual

13
Optical Bypass Switch with Heartbeat
Connecting to the In-line Device
To connect the bypass switch to the in-line device:
1. Connect Monitoring Port C to the in-line appliance using a duplex LC ber
cable. This acts as your DCE interface.
2. Connect Monitoring Port D to the in-line appliance using a duplex LC ber
cable. This acts as your DTE interface.
Figure 7: Connecting to the In-Line Device
3. Verify that the bypass switch Monitoring Ports are cabled in-line to the
attached device.
4. Connect power to the switch. If you are implementing power fault failover,
make sure you connect the switches' power supplies to the same power
sources that the IPS is using.
www.netoptics.com
®
Optical Bypass Switch
LASER
CAUTION!
2
1
BYPASS ON OFF
ACT
LINK
B 1 2A
OUT IN OUT IN OUT IN OUT IN
Network Monitor
A B 1 2
Rx
B
To monitoring device
To monitoring device
Tx
A