Instruction Manual
18
Step 5
Connect to the Network
The iBypass 40G Switch Network ports require 40G MTP cables.
Network port B to
a network switch
or router
Network port A to a
network switch or
router
Figure 10 - MTP Cables to the Network
1. Connect Network Port A to a network device with a 40G MTP cable.
2. Connect Network Port B to another network device using another 40G MTP
cable.
3. Verify that the Network ports are cabled in-line between two network devices.
4. Verify the link status LED illuminates for each connected port.
5. Verify the ACT LED ashes when there is trafc on the network link.