Instruction Manual

Step 3 (cont.)

Option 2 - Connect PC to the Console Port

1. Connect a PC running terminal emulation software to the iBypass 40G Switch

Console port with the supplied DB9-RJ45 console cable. See Figure 6.

2. Launch the terminal emulation software, such as HyperTerminal or minicom,

and set the communication parameters to 115,200 baud, 8 data bits, no parity,

1 stop bit, and no ow control.

3. At the prompt, enter admin for the user and netoptics for the password.

4. Change the password for the admin account by entering the following

command at the prompt:

modify user password admin <new_passwd> <re-enter_passwd>

where <new_passwd> is the new password for the admin account and

<re-enter_passwd> is your password entered again.

5. Go to Congure the IP section and follow the instructions to set a new IP

address.

For more information about using the iBypass 40G Switch CLI, enter help to display

command information or see the iBypass 40G Switch User Guide for more details.