Instructions / Assembly

Align the mounting positions of the Seat（B) onto Backrest（A）
If the mounting position not line up enough,can slightly shake the Seat up and
down.
Attach the Backrest（A）to Seat（B) using Hardware（①&②）with Allen Key
（③）as shown above.
DO NOT FULLY TIGHTEN THE BOLTS.
Step 5
Stand CHAIR right side up.
Check stability and then tighten the bolts.
If it wobbles,lift the chair some 30cm to 50cm high from the ground.
Keep your feet and toes well away from the drop zone.
Drop the chair freely and vertically with all four legs,htting the ground,all at the
same time.
Test again for evenness on a LEVEL SURFACE.
If no wobbles are found,slowly and steadily,place the chair facedown.
Then，proceed to tighten all bolts in a sequential manner.
When tightening any bolt，tighten sequentially.
Note:DO NOT fully tighten a BOLT in one go and then move on to the
next.Rather,in a sequential manner,gradually tighten each Bolt until all
bolts are evenly secured.This methodology will ensure maximum
evenness once all Bolts are fully tightened.
Step 6
Put the Seat Cushion （E) on the Seat.
Your Chair is ready for use.
The Chair can only be used on the flat and level surface.
Page 4 OF 5