Use and Care Manual

3
English
Operating Instructions
1. Remove all packaging materials before using the rst time.
2. Wash parts with soapy water and rinse. Reduce splashing and dump
dirty water by lifting Tub from Motor Drive to keep water from entering
Motor Drive area. CAUTION: ALWAYS WEAR SAFETY GLOVES
WHEN REACHING INSIDE OF DRUM!
3. Rotate Drive Coupling until slot is horizontal. Using Tub handles, lift
Drum and insert Drive Shaft into Drive Coupling. Lower the opposite
end shaft of Drum into groove on Bearing Block.
4. Place unit on level surface and add water to the “Maximum Fill Line”.
Water level inside of Drum should be 1/4” to 1/2” above the bottom.
CAUTION: DO NOT POUR WATER OVER MOTOR DRIVE!
5. Release Latch by lifting and open door, place sh into Drum. For best
results load scaler by similar size and types of sh.
6. Note: TD-6065-13 (18” long drum) will scale up to 50 small pansh
and TD-6065-13L (26” long drum) is designed to scale large s up to
22” in length.
Parts and Accessories
Locking
Latch
Water
Tub
Drum
On/Off
switch
Handle
Motor
Drive
Hinged
Door
Drive
Coupling
Bearing
Block
Maximum
Fill Line
Drive Shaft