User manual

Edit Profile Window

Nero Recode

even and odd half images simultaneously. This way, one half image

fills in the lines missing from the other half image. The Weave dein-

terlacing method is appropriate if both half images originate from the

same point in time and can be interlaced inconspicuously.

Blend: Consecutive interlaced fields are combined and then aver-

aged together. This is very fast, but image details in the vertical axis

may be removed. So called ghost artifacts may also occur and reso-

lution may be lost.

Interpolate: One of the two interlaced fields gets discarded com-

pletely, and each discarded line is replaced by an average of its up-

per and lower neigbour from the other field. This is very fast, but

image details in the vertical axis may be removed.

Interpolate Adaptive: Similar to Interpolate, but discards only sec-

tions which are not needed. Therefore, it is not as fast as Interpo-

late, but gives better detail result.

Motion Adaptive: The amount of image motion and the motion di-

rection is taken into consideration for the interpolation.

The selected deinterlace method will be only applied if deinterlacing

of the source video is possible!

Button

Encoder settings

Opens a window with enhanced encoder settings for the selected

codec (see Encoder Settings Window→ 67

Only active if encoder settings are available.

6.2 Encoder Settings Window

In the Encoder Settings window you can change settings for a specific codec. The window

is opened by choosing a codec in the Edit Profile window and clicking the Encoder set-

tings button. We recommend to only change these settings if you have experienced

knowledge in this area!

Note that only those settings and values are shown that are possible and applicable for the

selected profile!