4

Options Window
Nero BackItUp 78
Check box
Enable Push-for-Backup
device button
Enables the "Push for Backup" service. This service can
be started only from an appropriately equipped external
hard drive and the corresponding software with the help of
the hard drive's "Push for Backup" button, and carries out
a previously defined backup automatically with Nero
BackItUp.
Information about this feature is normally available in the
Help of the respective hard drive or application.
System shutdown selecti-
on list
Specifies whether the system will be switched off and if so,
when.
Check box
Show all message boxes
Shows all messages that you have disabled.
Slider
Thread priority
Specifies the priority of Nero BackItUp processes in the
system. If the Idle value is selected, Nero BackItUp proc-
esses are only started when the system is running no
other or only standard processes.
Comments
Allows you to enter a standard comment.
14.2 Backup Tab
The Backup tab offers setting options for backups.
The following setting options are available in the Backup Profile Selection area:
Drop-down menu
Standard profile
Selects a profile as the default profile for backups.
A profile consists of defined filters and settings on this tab.
Button
Save
Saves an edited profile under a new name.
This button is only enabled if you have changed settings -
and therefore the profile - on this tab.
Button
Remove
Removes the selected profile.
The standard profile cannot be deleted.
The following setting options are available in the Options area:
Check box
Do a virus check before
backup
Checks the files and performs a virus check before
backup.
Check box
Encrypt backup
Encrypts the backup; you must set a password.
Check box
Verify data after backup
Verifies whether the data is complete and readable after
backup.