User's Manual

viii
Cet appareillage numérique de la classe B répond à toutes les exigences de l'interférence
canadienne causant des règlements d'équipement. L'opération est sujette aux deux conditions
suivantes: (1) ce dispositif peut ne pas causer l'interférence nocive, et (2) ce dispositif doit accepter
n'importe quelle interférence reçue, y compris l'interférence qui peut causer l'opération peu désirée.
FCC Information:
This device complies with part 15 of the FCC rules. Operation is subject to the following three
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
(3) For RF exposure, service personnel are to maintain a minimum of 20cm from the RF
communications transmitter once installed.
Changes or modifications not expressly approved by Landis+Gyr could void the
user’s authority to operate the equipment.
Do not change the original antenna without pre-approval from the original
meter manufacturer. This will violate the FCC regulations of using the radio.
Note:
Some Focus meters may contain AMR modules with RF communications. This equipment has been
tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult Landis+Gyr or an authorized technician for help.
Following are FCC identification numbers for radio systems currently used on FOCUS:
Cellnet FCC ID: ROV-CLTR900M
Neptune FCC ID: P2SNTGSRFE01
StatSignal FCC ID: ROV-1MWR9165