User Manual

cellnetmiu Rev. 0

12/3/98 4:32 PM

Note: If the MIU will be connected to a Pro-Read ¨ encoder register, the Pro-Read ¨ must be

programmed for three-wire mode using a Pro-Read

¨ programmer and its ten-digit TDI

format. Do this through the Pro-Read

¨ receptacle before removing the receptacle.

6 Using a Scotchlok crimping tool or a

pair of Channel locks, squeeze the

ÒbuttonÓ on the Scotchlok until it is

completely flat (Figure 2.14).

7 Inspect the Scotchlok to verify that

both wires are fully inserted. If they are

not, redo the splice (Figure 2.15).