User's Manual

This manual is an unpublished work and contains the trade secrets and confidential infor-

mation of Neptune Technology Group Inc., which are not to be divulged to third parties

and may not be reproduced or transmitted in whole or part, in any form or by any means,

electronic or mechanical for any purpose, without the express written permission of Nep-

tune Technology Group Inc. All rights to designs or inventions disclosed herein, including

the right to manufacture, are reserved to Neptune Technology Group Inc.

The information contained in this document is subject to change without notice. Neptune

reserves the right to change the product specifications at any time without incurring any

obligations.

Trademarks used in this manual

MRX920

and EZRouteMAPS

are trademarks of Neptune Technology Group Inc.

RouteMAPS



is a registered trademark of Neptune Technology Group Inc.

Other brands or product names are the trademarks or registered trademarks of their

respective holders.

FCC Notice:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

“NOTE: This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help”