User Manual
Table Of Contents
- 16-0202 - Exhibit Cover.pdf
- MRX920v3 User Manual.pdf
- MRX920™ User’s Manual
- Chapter 1 Introduction
- Chapter 2 Specifications
- Chapter 3 Getting Started
- Chapter 4 Troubleshooting
- Glossary
- Index
Troubleshooting
4-2 MRX920 User’s Manual
My USB connection isn't working.
Cable is unplugged.
Be sure the USB cable is secure on
both the laptop end and the MRX920
end.
Cable is damaged. Try any other USB cable.
Connected through other method.
Check Receiver Settings to ensure
that you are connecting as you
intended (Bluetooth vs. USB).
Look at front of the MRX920. The
LEDs labeled Bluetooth and USB
flashes slowly when not connected,
and flashes quickly on the chosen
connection method (Bluetooth or USB)
within the first few seconds of being
connected. Flash continues extremely
fast.
Not getting readings.
Unit is not connected correctly.
As long as the Rx LED is changing
from on to off, your MRX920 is
receiving readings.
RF antenna is damaged.
Check the antenna for any crimps or
damage.
Power is applied, the MX900 host
software executes, but no route
data is available.
USB flash drive not inserted.
Make sure the USB flash drive is
properly inserted into an available USB
port on your laptop, or route files did
not properly download from the
network.
Incompatible data on USB flash drive.
Select the Self-Diagnostics tab to
verify that the data on the USB flash
drive is compatible.
Table 4.1 Hardware Troubleshooting Table
Problem Probable Cause Things to Check