User Manual
Table Of Contents
- 72126503 - Exhibit Cover
- For FCC_IM_L900 Pit_09262017
- L900™ MIU Pit Installation and Maintenance Guide
- Copyright
- Chapter 1: Product Description
- Chapter 2: L900 Specifications
- Chapter 3: General Installation Guidelines
- Chapter 4: Pit Installation
- Chapter 5: Data Logging Extraction
- Chapter 6: Maintenance and Troubleshooting
- Chapter 7: Contact Information
- Glossary
- Index
- Neptune Locations
S
Scotchloks
Gel caps used to connect the register to the pigtail from the L900 MIU.
seal wire
Wire inserted into the seat holes adjacent to the main housing fastner screw. This seal must
be broken to remove the main housing from the mounting adapter.
serial number
Unique identification number given to each L900 MIU at the factory. Custom serial numbers
are not available.
splice tube
Device used to join two pieces of wire.
strain relief posts
Posts located on the encoder register and the back of the main L900 MIU housing.
T
terminal screw
Screws on the encoder register face that are used to connect and anchor the three (3)
conductor wire to the register.
terminal screw cover
Plastic cover on the encoder register that protects the terminal screws and exposed wires.
transmission time
Time between L900 MIU transmissions. The default is approximately fourteen (14) seconds.
Custom time is not available.
L900 MIU Pit Installation and Maintenance Guide 41
Glossary