User Manual
Table Of Contents
- 72129069 - Exhibit Cover
- CORRECTED R900 BCT3 User Manual PUBLICATION_UM R900 BCT 10.17
- R900® Belt Clip Transceiver Users’ Manual
- Setting Up the R900 Belt Clip Transceiver
- Introduction
- R900 Belt Clip Transceiver Overview
- Nomad Handheld and R900 BCT
- Unpacking and Inspecting Equipment
- R900 BCT Components
- Using the R900 BCT
- Accessing the R900 BCT Status Screen
- Using the R900 BCT to Read a Route
- Using the R900 BCT for Field Presentment and Field Service
- Updating R900 BCT Firmware
- How the Firmware Update Works
- Index
- Neptune Locations
Function LED Color Explanation
Installed mode Magenta
1.
Press
ENT
and release.
2.
Press
ENT
again and hold for five
seconds, then release.
The Mode LED is Magenta.
3.
Connect the USB.
The USB charger must be capable of suppling
1A of current.
USB mass storage White
The SD card appears as an external drive to the
PC.
To enter this mode:
1.
Connect the USB to the R900BCT and
to the PC.
The USB must be connected before the unit can
enter the USB mass storage mode.
Press until Mode LED flashes white.
1.
Press
MODE
until the Mode LED flashes
white.
2.
Press
ENT
.
The SD card now shows as an external
drive attached to the PC.
Table 2 – R900BCT Modes (continued)
6 R900 Belt Clip Transceiver User's Manual
Setting Up the R900BeltClipTransceiver