User Manual
Table Of Contents
- 14-0066 - Exhibit Cover.pdf
- PUBLICATION_UM Handheld_12.13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
- Neptune Locations
Introduction
1-2 N_SIGHT R900 User’s Manual for the Neptune Handheld System
Screen Shots Used in this Manual
In order to be consistent with the representation of all the screens
in this manual. the screens used in this guide are captured on the
Nomad. However, they appear very similarly on the other
handheld device.
Differences in Screen Appearances
The most predominant differences in the appearances of the screens on
both handheld devices are the following.
• CE5320 screens appear in a land
scape or horizontal format.
• The Nomad screens appear in a po
rtrait or vertical format.
The Note icon identifies information that clarifies a point within
the text.
The Setup icon identifies a part of the application program that
needs only periodic adjustment.
The Meter Reader icon identifies tasks that are usually
performe
d by a meter reader.
The Operator icon identifies tasks that are usually performed b
y
a N_SIGHT R900 operator.
Save data Messages that appear in the display of the handheld are in
Courier type.
Admin Keyboard entries are in Courier
bold type.
Save As Menu titles and menu selections shown in the display of the
handheld are in bo
ld type.
enter Keys that appear on the face of the handheld are in
SMALL CAPS.
Except for the chapter dedicated to setting up and using the CE5320B, this
manual uses the Nomad screens. However, the CE5320B screens are very
similar.