User Manual
Table Of Contents
- 14-0066 - Exhibit Cover.pdf
- PUBLICATION_UM Handheld_12.13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
- Neptune Locations
Maintaining and Repairing the Neptune Handheld System
9-24 N_SIGHT R900 User’s Manual for the Neptune Handheld System
4 Pull the door toward you to access
the battery.
5 Hold the R900 BCR vertically, right
side faci
ng up, with one hand over
the open compartment.
The battery is located on the right
side. See Figure 9.16.
Figure 9.16 Battery Inside Compartment
6 Vigorously tap the top of the R900 BCR until the battery loosens
for removal
Replacing the Battery
To replace the battery in its compartment, complete the following steps.
1 Open the battery door of the R900 BCR. See Steps 1 through 4 of
“Removing the Battery,” on page 9-23.
2 Have the front view of the R900 BCR facing up.
3 Hold the battery horizontally with the label facing down.
Battery
inside
The battery can be difficult to remove when fully charged.