User Manual
Table Of Contents
- 14-0066 - Exhibit Cover.pdf
- PUBLICATION_UM Handheld_12.13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
- Neptune Locations
Maintaining and Repairing the Neptune Handheld System
9-22 N_SIGHT R900 User’s Manual for the Neptune Handheld System
Using the Charger
The supported lithium ion battery charger is designed to charge the
Neptune 3.7VDC 5000mAh Li-Ion battery P/N 13143-001. The
following illustration shows the supported external battery charger, sold
separately as an accessory PN: 13148-001.
Figure 9.13 External Battery Charger
To charge the battery using the external battery charger, complete the
following steps.
1 Place the charger on a flat and stable surface.
2 Connect the charger to an AC wal
l plug using the AC cable deliv-
ered together with the device.
The three colors of the LED flash
for about 1 second each (red –
yellow – green). After that, the LED sequence flashes, and the
charger is ready for use.
3 Remove the charger from the wall plug if it will not be used for
lon
g period time.
Do not try to charge any other battery with this device.
If an error is identified, the LED turns red. Immediately remove the
battery from the charger.