User Manual
Table Of Contents
- 14-0066 - Exhibit Cover.pdf
- PUBLICATION_UM Handheld_12.13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
- Neptune Locations
Maintaining and Repairing the Neptune Handheld System
N_SIGHT R900 User’s Manual for the Neptune Handheld System 9-13
Figure 9.10 Opening the Velcro Closure
Replacing
To replace the existing strap or to install a new one, use the following
procedure.
1 Fold the slotted end of the handstrap back to form a hinge and
loosely secure the V
elcro closure.
2 Hold the door of the battery compartment
so that the screws face
you. Then, push the slotted ends of the handstrap through the two
holes on the door.
3 Turn the door over so that the inside of the door is facing you, and
slid
e the small metal pin that you removed earlier through the slots
of the handstrap. If you have difficulty inserting the pin, try loosen-
ing the Velcro tab and pushing more of the handstrap through the
hol
es on the door.
4 Fold the protective foam flap over the battery and replace the door
of
the battery compartment.
5 Secure the door of the battery compartment to
the back panel of the
CE5320 by turning each of the four captive screws clockwise until
you feel some resistance.