User Manual
Table Of Contents
- 14-0066 - Exhibit Cover.pdf
- PUBLICATION_UM Handheld_12.13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
- Neptune Locations
Using the Field Programmer
8-48 N_SIGHT R900 User’s Manual for the Neptune Handheld System
Using the Gas Format
To use the newly created gas format to program gas registers, complete
the following steps.
1 Select Conf
igure Gas from the Field Programmer Menu. See
Figure 8.5 on page 8-7.
2 When prompted, enter your password. See “Starting
Field Programmer,” on page 8-6.
3 Select the SelectFMT tab
.
4 Complete the steps outlined in “Selecting a Gas Format,” on page
8-41.
5 Refer to “Programming the R900G Endpoint,” on page 8-18 to pro-
gram or read the R900G endpoint
using the newly created format.
Deleting a Format for R900G Endpoints
To delete a gas format used for programming R900G endpoints,
complete the following steps.
1 Select Conf
igure Gas from the Field Programmer Menu. See
Figure 8.5 on page 8-7.
2 When prompted, enter your password. See “Starting
Field Programmer,” on page 8-6.
3 Select NewFMT.
The New Format screen appears as illustrated in Figure 8.39 on
page 8-43.
4 Touch since the NewFMT screen now defaults to New,
then shift the numbers to compensate.
5 Touch to delete the format from the lis
t of available for-
mat.
A confirmation dialog asking you to confirm the deletion.