User Manual
Table Of Contents
- 14-0066 - Exhibit Cover.pdf
- PUBLICATION_UM Handheld_12.13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
- Neptune Locations
Using the Field Programmer
8-40 N_SIGHT R900 User’s Manual for the Neptune Handheld System
Configuring Gas
To select preferences for
programming a gas endpoint,
complete the following steps.
1On the
Field Programmer
Menu
, touch or click
Configure Gas. See Fig-
ure 8.5 on page 8-7.
The Field Programmer
Pa
ssword screen appears
as shown in Figure 8.37.
Figure 8.37 Configure Gas Password Screen
2On the Field Programmer Password screen, type your password
and do one of the following:
• Touch .
• Click
•Press Enter.
On this screen, you can also change your password as described in
“Changing Your Password,” on page 8-8 or you can cancel logging
in to the system
After entering your password, the Pr
eferences screen appears as
illustrated in Figure 8.30.
3 Select your preferences as described in “Configuring Gas,” on page
8-18.
If you cannot remember your password, you can touch or click Hint to display
a clue.