User Manual
Table Of Contents
- 14-0066 - Exhibit Cover.pdf
- PUBLICATION_UM Handheld_12.13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
- Neptune Locations
Using the Field Programmer
N_SIGHT R900 User’s Manual for the Neptune Handheld System 8-17
6 Repeat steps 1 through 5 to read another register, or choose one of
the following.
• Touch or click Pr
ogram to program the register.
• Touch or click Query
to query the register.
• Touch or click to return to the main screen.
Viewing Software and Firmware Information
It is important to know which version of the Field Programmer software
you are using when you contact Neptune Customer Support. To identify
the version of Field Programmer software or the firmw
are version of the
Field Programmer mouse you are using, complete the following steps.
1 Select Pr
ogram Pro-
Read fr
om the
Field Programmer
men
u.
2 Select the Info tab.
The software and
fi
rmware information
appears. See Figure
8.17.
Figure 8.17 ProRead Software and Firmware Information
3 Touch or click to return to the Field Programmer Menu.
If an error message appears during a read attempt, it is most likely due to
improper format information.