User Manual
Table Of Contents
- 14-0066 - Exhibit Cover.pdf
- PUBLICATION_UM Handheld_12.13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
- Neptune Locations
Setting Up the R900 Belt Clip Receiver
N_SIGHT R900 User’s Manual for the Neptune Handheld System 5-13
Selecting the R900 Belt Clip Receiver Reading Mode
To choose the reading mode, complete the following steps.
1 On the Nomad, click .
2Click
– Utilities.
3Cl
ick – R900 Belt Clip Receiver St
atus.
The R900 Belt Clip Receiver Status screen appears.
4 Tap the drop-down selection list for RF Mode and y
ou can choose
the reading mode. See the modes listed above.
Using the R900 Belt Clip Receiver RF Test Mode
RF Test Mode allows the R900 BCR to go into a continuous receive
mode and listens for any and all R900 transmissions.
From the Login Screen
To access RF Test Mode from the
Login screen, complete the
following steps.
1 On the Nomad, click
.
2Click
– Utilities.
3Click – RF Test.
The RF Test Mode screen
appears as illustrated in Figure
5.4.
Figure 5.4 R900 Belt Clip Receiver RF Mode Screen
5
8
5
7