User Manual
Table Of Contents
- 14-0066 - Exhibit Cover.pdf
- PUBLICATION_UM Handheld_12.13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
- Neptune Locations
Setting Up the R900 Belt Clip Receiver
5-10 N_SIGHT R900 User’s Manual for the Neptune Handheld System
Understanding the External Battery Charger Status
Refer to the following table for a description of the external battery
LED.
Pairing the Trimble Nomad to the R900 Belt Clip Receiver through the Bluetooth
Complete these steps only if you are pairing the Nomad to the
R900 BCR for the first time.
Pairing the Trimble Nomad
To pair the Nomad to the R900 BCR, complete the following steps.
1 Power ON the R90
0 BCR and set to Normal Node, if not already
set. See “Understanding the R900 Belt Clip Receiver LED Operat-
ing Modes,” on page 5-8.
2 On the Nomad, click .
3Click – UT
ILS.
4Click – Belt C
lip Status.
The AMR Connection screen appears. The
R900 BCR is visible in
the Broadcasting Device drop-down selection list.
5 Choose the device from the drop-down selection list and click
Blueto
oth.
Table 5.5 External Battery Charger LED
LED Indicates
Red, yellow, green or
OFF
Startup initialization when applying power
OFF No battery inserted
Yellow Battery charging
Solid green Battery charged successfully
Red Error condition
8