User Manual
Table Of Contents
- 14-0066 - Exhibit Cover.pdf
- PUBLICATION_UM Handheld_12.13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
- Neptune Locations
Setting Up the R900 Belt Clip Receiver
5-6 N_SIGHT R900 User’s Manual for the Neptune Handheld System
To enter from when connected to vehicle power:
1 Press until the Mode LED is yellow.
2 Press and release.
3
Press again and hold for five seconds, then
release.
The Mode LED is Magenta.
4 Connect the USB.
The USB charger must be capable of suppling 1A of
current.
USB mass
storage
(White) The SD card appears as
an external drive to the PC.
To enter this mode:
1 Connect the USB to the
R900 BCR and to the PC.
The USB must be connected before the unit can enter
the US
B mass storage mode.
2 Press until Mode LED flashes white.
3P
ress .
The SD Card now shows as an external drive
attached to the PC.
Table 5.2 R900 Belt Clip Receiver Modes
Function LED Color Explanation
MODE
ENT
ENT
MODE
ENT