User Manual
Table Of Contents
- 14-0066 - Exhibit Cover.pdf
- PUBLICATION_UM Handheld_12.13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
- Neptune Locations
Using the Nomad Handheld
4-28 N_SIGHT R900 User’s Manual for the Neptune Handheld System
help you reduce errors by making sure that you press each key fully. If
you do not press a key fully, the handheld does not acknowledge your
entry. You can turn the Key Clicks feature on or off at any time.
4 Do one of the following:
• Select the check box to enable Key
Clicks.
• Leave the check box empty to disable the Key
Clicks.
These settings toggle between on (checked)
or off (unchecked)
according to the current setting.
5 Touch OK to
save your settings.
You return to the reading-entry screen
or your previous screen.
Configuring RF/Serial Properties
Depending on the type of accounts on your route, you may have to
configure the RF antenna, the type of probe, or serial properties you are
using. Follow this procedure to configure or change the RF antenna, the
type of probe, or serial properties.
1 Press .
The Syst
em
Menu appears as
illustrated in
Figure 4.17.
Figure 4.17 N_SIGHT R900 F1 Menu