User Manual
Table Of Contents
- 14-0066 - Exhibit Cover.pdf
- PUBLICATION_UM Handheld_12.13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
- Neptune Locations
Using the Nomad Handheld
N_SIGHT R900 User’s Manual for the Neptune Handheld System 4-9
7 Tab to the HHU ID field, and type the ID of the handheld.
8 Type the IP address of the PC
which you want the Nomad to
synchronize within the Server Name field.
9 Be sure the Port is 251
01.
10 Click OK.
The handheld resets, and the N_SIGHT R900 Login screen
appears.
The Display and Keyboard
This section describes the display and keyboard on the Nomad.
• The types of information that are shown in the display of the
hand
held.
• An overview of how to use the keys to access
different types of
information.
Learning the Keyboard
The Nomad handheld uses 51 keys to give you access to all the stored
information and to allow you to enter new data. Most keys perform
more than one function.
The HHU ID for the Nomad can be found four ways:
• On the outside of the box in which the Nomad is packaged.
• In the battery compartment on the right side.
• Navigate to Windows Icon, Settings, System Tab at bottom of the
screen,
and then scroll to System Information and Info Tab at bottom of
screen.
• Navigate to Windows Icon, Settings, System Tab at bottom of the
screen and
click About then Device ID at the bottom of the screen.
If the message DB Uninitialized flashes on the screen press Synchronize
once more to complete Database Synchronization