User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Using the CE5320 Handheld
3-28 N_SIGHT R900 User’s Manual for the Neptune Handheld System
3Click Ye s.
After you click Yes, the
Set Date/Time screen
appears as illustrated in
Fi
gure 3.20.
Figure 3.20 N_SIGHT R900 Set Date / Time Screen
4 If applicable, make any changes to the date and time.
The correct date and time to use is the date and time that the
handheld last syn
chronized.
5 When the date and time
are accurate, click OK.
The Handheld Login
screen appears as
illustrated in Figure 3.22.
Figure 3.21 N_SIGHT R900 Handheld Login Screen
The Reader ID field displays the information contained in the
N_SIGHT R900 software.
6 Complete the following information as applicable:
• Password (Determined by N_SIG
HT R900 setup)
• Vehicle # (Optional)
• Mileage (Op
tional)
If you answer NO to the
clock error message, the
Login screen appears again.
Pilot Release