User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Using the CE5320 Handheld
3-26 N_SIGHT R900 User’s Manual for the Neptune Handheld System
The RF/Serial
Properties screen
appears as illustrated
in Figure 3.17.
Figure 3.17 RF/Serial Properties Screen
Logging In and Out of the N_SIGHT R900
This section explains how to log into N_SIGHT R900 on the handheld
to access the screens needed to complete meter reading tasks.
Logging Into N_SIGHT R900 on the CE5320
After you have loaded a route, or after you have exchanged meter
readings and route data with the host computer, you need to log into
N_SIGHT R900 on the handheld. Signing on gives you access to the
screens you need to collect and exchange route and meter data.
Complete the following steps to log into N_SIGHT R900 on the
CE532
0.
1 If you have
not already done so, press turn on the CE5320.
F1
If you see the message Not Uploaded, this means the handheld has
been loaded but not yet been unloaded. This is normal if a new route was just
loaded to the handheld.
Touch or Synchronize to start Communications. For more
information, refer to “Communicating with the Host Computer,” on page 7-1.
S
’
Pilot Release