User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Using the CE5320 Handheld
3-24 N_SIGHT R900 User’s Manual for the Neptune Handheld System
Changing the Route Read Direction
The handheld typically displays meters of a route from the first meter to
the last meter. However, you can change the order that meters are
displayed so that they are shown from the last meter to the first meter.
4In the Route Dir fi
eld, touch the down
arrow and do one of the
following:
• Select FORWARD if you want the readings to adva
nce to the
next unread account in the route.
• Select BACKWARD if
you want to change the directions of
the readings to go backward to the previous unread account in
the route.
These settings toggles between Forward or Backward according to
the current setting.
Turning Key Clicks On and Off
The Key Clicks feature allows you to control how the handheld
responds when you press a key. When this feature is ON, the handheld
beeps whenever you press a key. Turning the Key Clicks feature on can
help you reduce errors by making sure that you press each key fully. If
you do not press a key fully, the handheld does not acknowledge your
entry. You can turn the Key Clicks feature on or off at any time.
5 Do one of the following:
• Select the checkbox to enable Key Cl
icks.
• Leave the checkbox empty to disable the Key
Clicks.
These settings toggles between on (checked)
or off (unchecked)
according to the current setting.
6 T
ouch OK to save you
r settings.
You return to the reading-entry screen or your previous screen.
Configuring RF/Serial Properties
Depending on the type of accounts on your route, you may have to
configure the RF antenna, the type of probe, or serial properties you are
using. Follow this procedure to configure or change the RF antenna, the
type of probe, or serial properties.
Pilot Release