User Manual
Table Of Contents
- 13-0249- Exhibit Cover.pdf
- UPDATED_Pilot Release_Handheld System 11 13.pdf
- Neptune Handheld System User’s Manual
- 1 Introduction
- 2 Overview of the Neptune Handheld System
- 3 Using the CE5320 Handheld
- 4 Using the Nomad Handheld
- 5 Setting Up the R900 Belt Clip Receiver
- R900 Belt Clip Receiver
- Nomad Handheld and R900 Belt Clip Receiver
- Unpacking and Inspecting Equipment
- Using the R900 Belt Clip Receiver
- Using the R900 Belt Clip Receiver to Read a Route
- Updating R900 Belt Clip Receiver Firmware
- 6 Gathering Route Data
- The Reading Entry Screen
- Manually Collecting Meter Readings
- Collecting RR Readings
- Working with Accounts
- Validating Readings
- Removing a Reading
- Clearing a Skip Code
- Clearing a Comment Code, Customer Note, or Trouble Code
- Adding a New Meter to a Route
- Correcting or Changing Meter Information
- Finding and Displaying Reading-Entry Screens
- Resequencing Routes
- 7 Communicating with the Host Computer
- 8 Using the Field Programmer
- Connecting the Mouse
- Starting Field Programmer
- Programming the ProRead
- Querying the ProRead
- Reading the ProRead Register
- Programming the R900G Endpoint
- Using Command Gas
- Reading the R900G Endpoint Register
- Networking Two Registers
- Managing Formats
- 9 Maintaining and Repairing the Neptune Handheld System
- 10 Troubleshooting
- Appendix A Changing Volume Settings
- Appendix B Tokens List for Custom Format Screen
- Appendix C Pressure Configuration Factor Indexes
- Glossary
- Index
Using the CE5320 Handheld
N_SIGHT R900 User’s Manual for the Neptune Handheld System 3-5
Connecting to the Host Computer and Power Supply
The procedures in this chapter describe how to connect the CE5320 to
the host computer so that it can exchange information with the host. The
procedures also describe how to connect a power supply to the
communications cradle so that you can recharge the battery. Complete
the following procedures to connect the equipment you have.
Connecting the Router, CE Handheld Cradle, and Power
Supplies
You need no special tools to connect the devices that were shipped with
your handheld. Follow this procedure to connect the router,
communication cradles, and power supplies.
1 If you have not already done so, make sure that you have all of the
equipment you need. If necessary, refer to the preceding section
“Unp
acking and Inspecting Equipment,” on page 3-2.
2 With the host computer OFF, connect the power supply to the
router.
This configuration is for handhelds not connected to a system network. If you
are connected to a system network, see the network specialist or your System
Administrator for assistance.
It is important that the router you use has the capability to work as a switch.
Pilot Release